hammer.ampage.org

123456789101112↑↓

 
hammer DEVICE Issue 5 1/28/101 7:47 pm
This was a newsletter for "electronic" guitarists that was published by Craig Anderton and Roger Clay in 1979, and lasted for 12 skinny but deep issues. Lots of useful info and nostalgia inside.
  • Modifications for EH Electric Mistress (add mix + init. delay controls, increase regeneration, add status LED)
  • Review of Yamaha E1010 Analog Delay
  • Cable capacitance; issues and measurement
  • Part 5,6,7 of AMS-100 guitar processor
    • control voltage processing modules


 
hammer DEVICE Issue 6 1/28/101 7:54 pm
This was a newsletter for "electronic" guitarists that was published by Craig Anderton and Roger Clay in 1979, and lasted for 12 skinny but deep issues. Lots of useful info and nostalgia inside.
  • Review of Blacet Music Research Phasefilter
  • Double-coil pickup modifications
  • Modifying the EH Micro Synth (for guitar), adjust Attack Delay, increase input impedance, improve octave above, add filter trigger indicator LED, add heat sink to regulator, improve suboctave high end
  • Part 8 of AMS-100 guitar processor
    • voltage controlled filter/phase-shifter (based on SSM2040)


 
hammer DEVICE Issue 7 1/31/101 7:39 am
This was a newsletter for "electronic" guitarists that was published by Craig Anderton and Roger Clay in 1979, and lasted for 12 skinny but deep issues. Lots of useful info and nostalgia inside.

- Review of MXR Digital Delay
- Modding the Big Muff Pi Deluxe
- Serial and parallel switching
- LED bargraph voltmeter


 
hammer DEVICE Issue 8 1/29/101 2:40 am
This was a newsletter for "electronic" guitarists that was published by Craig Anderton and Roger Clay in 1979, and lasted for 12 skinny but deep issues. Lots of useful info and nostalgia inside.

- Review of Korg SE-500 tape echo.
- Review of Memory Man Deluxe with Chorus.
- Voltage-Controlled Amplifier/Distortion module.
- Assortment of pedal mods.



 
hammer DEVICE Issue 9 1/29/101 2:55 am
This was a newsletter for "electronic" guitarists that was published by Craig Anderton and Roger Clay in 1979, and lasted for 12 skinny but deep issues. Lots of useful info and nostalgia inside.

- Flanger construction project Pt.1
- Review of Echoplex.
- Design standards for Special FX.
- Inverting op-amps.
- Creating floating grounds with 9v.



 
hammer DEVICE Issue 10 1/29/101 3:05 am
This was a newsletter for "electronic" guitarists that was published by Craig Anderton and Roger Clay in 1979, and lasted for 12 skinny but deep issues. Lots of useful info and nostalgia inside.

- Review of DOD 680 Delay.
- Flanger construction project Pt.2.
- DIY Power amp.
- Interview with Steven St. Croix, Pt.2.
- Rhythm generator module.



 
hammer DEVICE Issue 11 1/29/101 3:13 am
This was a newsletter for "electronic" guitarists that was published by Craig Anderton and Roger Clay in 1979, and lasted for 12 skinny but deep issues. Lots of useful info and nostalgia inside.

- Review of EH Polyphase.
- Mods for BOSS PH-1 & Small Stone.
- Pedalboards.
- Pluck follower module.
- MN3005 BBD chip specs.



 
123456789101112↑↓

hammer.ampage.org